Install Manual

Chapter 3: SolarEdge Device Configuration
ThissectiondescribesbasicconfigurationofSolarEdgedevices(inverter/CCG)forusingameter.In
addition,configurationspecifictotheapplicationbeingusedisrequiredinsomecases.Refertothe
followingdocuments:
l ExportLimitation-http://www.solaredge.us/files/pdfs/products/export_limitation_application_
note_NA.pdf
l ConsumptionandProductionMonitoring-
http://www.solaredge.us/files/pdfs/products/consumption_production_monitoring_application_
note.pdf
l StorEdgeSmartEnergyManagementoff-gridapplications-
http://www.solaredge.us/files/pdfs/storedge_backup_installation_guide_NA.pdf.
ForconfiguringtwoconnectedmetersrefertoInstalling Two Metersonpage19.
To configure the SolarEdge device:
UsethefouruserbuttonstocontroltheLCDpanelmenus:
l Esc:Goestothebeginningofthecurrentlyenteredparameterortothepreviousmenu.
l Up (1)andDown (2):Movesthecursor(>)totherelevantmenuoption.
l Enter (3):Usedtoselectanoption
1. VerifythatthedeviceON/OFFswitchisOFF.
2.
TurnONtheACswitchofthemaincircuitboard.
WARNING!
ELECTRICAL SHOCK HAZARD. Do not touch uninsulated wires when the inverter cover is
removed.
RISQUE D’ÉLECTROCUTION, ne touchez pas les fils non isolés lorsque le couvercle de l'onduleur
est retiré.
3.
PresstheEnter(3)buttonforatleastfiveseconds.Thefollowingmessageisdisplayed:
P l e a s e e n t e r
P a s s w o r d
* * * * * * * *
4. Usethethreerightmostbuttons(Up-1,Down-2andEnter-3)totypeinthefollowingdefault
password:12312312.
5.
ScrolltotheCommunicationmenuandselectRS485-X Conf(XrepresentstheactualRS485portto
whichtheelectricitymeterisconnected:1orEfortheinverter;1or2orEfortheCCG).Thefollowing
screenisdisplayed:
D e v i c e T y p e < S E >
P r o t o c o l < M >
D e v i c e I D < 1 >
S l a v e D e t e c t < # >
S l a v e L i s t < # >
SolarEdge SolarEdge Electricity Meter Installation Guide MAN-01-00270-1.0
12
Chapter 3: SolarEdge Device Configuration