Install Manual

3.
Connectthewiresasshownbelow:
Figure 14: Meter RS485 connections
4.
IftheSolarEdgedeviceisattheendoftheRS485bus,terminateasfollows:
l Inverter-TerminatebyswitchingaterminationDIP-switchinsidetheinvertertoON(top
position).TheswitchislocatedonthecommunicationboardandismarkedSW7.
l CCG-TerminatebyswitchingtheSW2terminationDIP-switchtoON.
Figure 15: RS485 termination switch
Chapter 2: Meter Installation
SolarEdge-SolarEdge Electricity Meter Installation Guide MAN-01-00270-1.0
11