Install Manual

To connect the meter to the inverter or CCG:
1.
Ifconnectingtoaninverter,removethesealfromoneoftheopeningsincommunicationgland#2at
thebottomoftheinverterandinserttheRS485wiresfromthemeterthroughtheopening.
Figure 10: Communication glands
2.
PreparetoconnecttooneoftheavailableRS485portsofthedevice,asshownbelow:
l InverterRS485-1-pulloutthe9-pinRS485connectorlocatedonthecommunicationboard.
Figure 11: Inverter RS485 connector
l InverterRS485Expansionmodule-pulloutthe3-pinconnector
Figure 12: Inverter RS485 Expansion module
l CCG-useoneofthe3-pinconnectorssuppliedwiththeCCG.ConnectittotheRS485-2
connectionontheCCG.
Figure 13: CCG RS485 connector
SolarEdge SolarEdge Electricity Meter Installation Guide MAN-01-00270-1.0
10
Installing and Connecting the Meter