Installation Manual

To Install the modem in the SolarEdge 1Ph inverter
(HD-Wave):
1. Locatethemodeminitsplaceonthecommunicationboard.Makesure
thatthemodemisfirmlyinplace(seeFigure 15).
2. Connecttheantennacabletothemodemandtightenmanually.
3.
Usethetie-wraptofastenthemodemtothecommunicationboard.
Figure 15: Installed modem
4. VerifythattheON/OFFswitchandSafetySwitch(ifinstalled)areOFF.
5.
TurntheACON.
WARNING!
ELECTRICAL SHOCK HAZARD. Do not touch uninsulated wires
when the inverter cover is removed.
CheckthatalltheGSMmodemLEDsarelit(see Figure 14).Ifnot,referto .6
Troubleshootingonpage21.
Chapter 3: GSM Modem and Antenna Installation
GSM Installation Guide MAN-01-00248-1.1
16