Installation Manual

7. Inserttherubbersealwiththecableintotheglandbodyandreconnect
theglandtotheinverter.Tightenthesealinggland.
8. Pulltheexcesscableintotheinvertersothatthecablecanbeattached
totheinvertercommunicationboard(seeFigure 13).Thecableconnects
totheGSMmodemasdescribedinthenextsection.
Installing the Modem in the Inverter
NOTE
If the GSM modem is pre-installed in the inverter (with a SIM card), this
step is not required.
NOTE
If you intend to use the RS485 communication, and termination is
required, adjust the termination DIP switches on the inverter
communication board before installing the modem, as the DIP switches
are inaccessible when the modem is installed.
NOTE
Make sure that the inverter version is 3.1600/3.18xx for SolarEdge data
plan or higher before installing the modem, otherwise the cellular
communication may be inoperative and the inverter will not start up.If
applicable, upgrade the inverter firmware using the supplied upgrade card.
1.
IfthereisnoSIMcardinstalledinthemodem,insertoneintothesloton
theGSMmodem.
Figure 9: Inserting the card into the GSM modem
2. Removetheinvertercoverasdescribedinitsmanual.
Chapter 3: GSM Modem and Antenna Installation
GSM Installation Guide MAN-01-00248-1.1
12