Install Manual
Table Of Contents
- Disclaimers
- Revision History
- Contents
- HANDLING AND SAFETY INSTRUCTIONS
- RISK OF FIRE AND ELECTRIC SHOCK PREVENTION IMPORTANT SAFETY INSTRUCTIONS
- Smart EV Charging Safety Instructions
- Chapter 1: Introduction to Smart EV Charger
- Chapter 2: Connectors and Interfaces
- Chapter 3: Configuring and Using Smart EV Charger with mySolarEdge
- Chapter 4: Charging Instructions
- Chapter 5: Professional Installer- Connecting the AC Directly to the Smart EV Charger
- Required Equipment
- Main Procedure
- Grid Connection Guidelines
- Setting the Circuit Breaker Ratings
- Supported AC Grids
- Removing the Smart EV Charger Covers
- Disconnecting the AC Plug
- Directly Connecting the AC Grid to the Smart EV Charger
- Connecting the Smart EV Charger to the Single phase inverter with HD-Wave tec...
- Closing the Smart EV Charger Covers
- Chapter 6: Professional Installer - Setting Up Communication
- Chapter 7: Processional Installer - Configuring and Using Smart EV Charger with SetApp
- Chapter 8: Errors and Troubleshooting
- Appendix A: Professional Installer - Connecting the Smart EV Charger to an Energy Meter
- Mechanical Specifications
- Technical Specifications - Smart EV Charger (North America)
- Support Contact Information
Technical Specifications - Smart EV Charger
(North America)
Level 2 EVSE, 40A (9.6kW), Wi-Fi enabled
EV CHARGER SPECIFICATIONS
Charging Mode AC Level 2
Rated AC Power Output 9.6 kW
Maximum Continuous
Output Current @240
40
(1)
Vac
Nominal AC Output
Voltage
240
(2)
Vac
Nominal AC Frequency 60 Hz
Ground Fault Detection
Threshold
5 mA
Supported Communication
Interfaces
Wi-Fi (built-in antenna included)
(3)
, Ethernet,
RS485 and Cellular (optional)
(4)
FEATURES SUPPORTED WITH INTEGRATED SOLAREDGE INVERTER
Smart Energy Management
Controlled excess solar charging
(5)
and solar
boost mode
ADDITIONAL FEATURES
EV Charger Status LEDs,
Fault Indicator
Yes
EV Charger Unplugging
Detection
Yes, current termination according to SAE
J1772 EV Charger
EV Charger Ground
Connection Monitoring
Yes, continuous
EV Charger Configuration
Installer commissioning via SetApp.
Homeowner configuration controls and
monitoring via mySolarEdge app
(1)
Can also be configured to 16A, 24A and 32A.
(2)
Connected to L1, L2, G; No need for neutral.
(3)
To extend Wi-Fi communication, use optional Wi-Fi antenna. For antenna specification refer to se-wifi-
zigbee-wireless-antenna-datasheet-na.pdf
(4)
Optional cellular kit can be ordered.
(5)
When Smart EV Charger is connected to inverter, Import/Export meter is required for controlled Excess
Solar charging
Smart EV Charger Installation MAN-01-00657-1.0
53 Technical Specifications - Smart EV Charger (North America)