Install Manual

Table Of Contents

4.

Loosen the screws of the connector and remove the DC-to-DCunit wires. Twist the

DC-to-DC unit wires together with the Energy Meter wires (B with B, A with A, G

with G). (see

Figure 13

You can use any color wire for each of the A, B and G connections, as long as:

The same color wire is used for all A pins the same color for all B pins and the

same color for all G pins

The wire for G is not from the same twisted pair as A or B.

5. Insert the twisted wires into the connector and tighten them with the screws.

6. Connect the connector back to the RS485-1 port.

7. In the meter, ensure the RS485-1 DIPswitch is down. See

Figure 12

8. In the meter, set the Modbus address 1-3 of the meter according to

Table 1

Smart EV Charger Installation MAN-01-00657-1.0

51 Energy Meter DIPSwitches