Install Manual
Table Of Contents
- Disclaimers
- Revision History
- Contents
- HANDLING AND SAFETY INSTRUCTIONS
- RISK OF FIRE AND ELECTRIC SHOCK PREVENTION IMPORTANT SAFETY INSTRUCTIONS
- Smart EV Charging Safety Instructions
- Chapter 1: Introduction to Smart EV Charger
- Chapter 2: Connectors and Interfaces
- Chapter 3: Configuring and Using Smart EV Charger with mySolarEdge
- Chapter 4: Charging Instructions
- Chapter 5: Professional Installer- Connecting the AC Directly to the Smart EV Charger
- Required Equipment
- Main Procedure
- Grid Connection Guidelines
- Setting the Circuit Breaker Ratings
- Supported AC Grids
- Removing the Smart EV Charger Covers
- Disconnecting the AC Plug
- Directly Connecting the AC Grid to the Smart EV Charger
- Connecting the Smart EV Charger to the Single phase inverter with HD-Wave tec...
- Closing the Smart EV Charger Covers
- Chapter 6: Professional Installer - Setting Up Communication
- Chapter 7: Processional Installer - Configuring and Using Smart EV Charger with SetApp
- Chapter 8: Errors and Troubleshooting
- Appendix A: Professional Installer - Connecting the Smart EV Charger to an Energy Meter
- Mechanical Specifications
- Technical Specifications - Smart EV Charger (North America)
- Support Contact Information
Error code Displayed Error message Description and Troubleshooting
Verify proper clearances around the
Smart EV charger Cable.
After verification reconnect the
Smart EV charger cable to the EV.
Contact SolarEdge Support.
1CxA
Under Voltage
Press Charge Now
Smart EVCharger ACvoltage too
low.
Press the Charge Now push
button on the Smart EVCharger,
see
Figure 2
-or-
Tap Charge Now on the EV Smart
Charger tab of the Monitoring
App
1CxC
Vent not supported
Disconnect from EV
The SolarEdge Smart EV charger
does not charge vehicles that
require ventilation while charging.
If this error occurs, the vehicle
cannot be charged.
1CxE;1CxF
Charging retries ended
Disconnect from EV
Charging retries ended
Disconnect the Smart EVCharger
cable from the vehicle.
Contact SolarEdge Support.
Chapter 8: Errors and Troubleshooting 48
Smart EV Charger Installation MAN-01-00657-1.0