Install Manual

RJ45 Pin #
Wire Color
(1)
10Base-T Signal
100Base-TX Signal
T568B T568A
1 White/Orange White/Green Transmit+
2 Orange Green Transmit-
3 White/Green White/Orange Receive+
4 Blue Blue Reserved
5 White/Blue White/Blue Reserved
6 Green Orange Received-
7 White/Brown White/Brown Reserved
8 Brown Brown Reserved
7. Use a pre-crimped cable to connect via gland #1 to the RJ45 plug on the Smart EV
Charger's communication board or, if using a spool of cable, connect as follows:
a. Insert the cable through the gland.
b. Remove the cable’s external insulation using a crimping tool or cable cutter and
expose eight wires.
c. Insert the eight wires into an RJ45 connector, as described in
d. Use a crimping tool to crimp the connector.
e. Connect the Ethernet connector to the RJ45 port on the communication board
(see the following figure).
(1)
The Smart EV Charger connection does not support RX/TX polarity change. Supporting crossover
Ethernet cables depends on the switch capabilities.
Chapter 6: Professional Installer - Setting Up Communication 40
Smart EV Charger Installation MAN-01-00657-1.0