Install Manual
Table Of Contents
- Disclaimers
- Revision History
- Contents
- HANDLING AND SAFETY INSTRUCTIONS
- RISK OF FIRE AND ELECTRIC SHOCK PREVENTION IMPORTANT SAFETY INSTRUCTIONS
- Smart EV Charging Safety Instructions
- Chapter 1: Introduction to Smart EV Charger
- Chapter 2: Connectors and Interfaces
- Chapter 3: Configuring and Using Smart EV Charger with mySolarEdge
- Chapter 4: Charging Instructions
- Chapter 5: Professional Installer- Connecting the AC Directly to the Smart EV Charger
- Required Equipment
- Main Procedure
- Grid Connection Guidelines
- Setting the Circuit Breaker Ratings
- Supported AC Grids
- Removing the Smart EV Charger Covers
- Disconnecting the AC Plug
- Directly Connecting the AC Grid to the Smart EV Charger
- Connecting the Smart EV Charger to the Single phase inverter with HD-Wave tec...
- Closing the Smart EV Charger Covers
- Chapter 6: Professional Installer - Setting Up Communication
- Chapter 7: Processional Installer - Configuring and Using Smart EV Charger with SetApp
- Chapter 8: Errors and Troubleshooting
- Appendix A: Professional Installer - Connecting the Smart EV Charger to an Energy Meter
- Mechanical Specifications
- Technical Specifications - Smart EV Charger (North America)
- Support Contact Information
Connecting the AC cable between the Single phase inverter
with HD-Wave technology and the Smart EV Charger
Figure 8: Single phase inverter with HD-Wave technology connected to Smart EV Charger
To connect the AC cable between the Single phase inverter with HD-Wave
technology and the Smart EV Charger:
1.
Disconnect the AC plug from the bottom of the Smart EV Charger. See
Disconnecting the AC Plug
on page 26
2. Insert the AC cable that contains the L1, L2 and grounding wires through the
opened conduit on the side of the DC Safety Unit.
3. Connect the AC wires according to the labels on the terminal block (see the
following figure).
Smart EV Charger Installation MAN-01-00657-1.0
33 Connecting the Smart EV Charger to the Single phase inverter with
HD-Wave technology