Install Manual

4. Release the gland nut. See Figure 6 .
5. Pull out the AC Plug cable from the conduit entry. See Figure 6 .
Directly Connecting the AC Grid to the Smart EV
Charger
To directly connect the AC grid to the Smart EV Charger:
1. Strip 15/32'' (12mm) of the 14-6 AWG AC wire insulation.
2.
Connect the conduit ground with a 14-6 AWG wire to the GND (see the figure in
step 5).
3. Insert the AC conduit into the AC conduit entry.
NOTE
Connect the equipment grounding before connecting the AC wires to the AC
terminal block.
Veillez à relier le conducteur de PE (la terre) avant de connecter les fils CA au
bornier CA.
4.
Insert the AC cable through the conduit entry and tighten the screws (see the figure
in step 5).
5.
Insert the wires into the round openings according to the labels on the terminal
blocks (G, L2 and L1) and close the levers – the wires are automatically clamped (see
the following figure).


Smart EV Charger Installation MAN-01-00657-1.0
27 Directly Connecting the AC Grid to the Smart EV Charger