P400 Installation

Verifying the Connection
Afterconnectingandconfiguringacommunicationoption,performthefollowingstepsto
checkthattheconnectiontothemonitoringserverhasbeensuccessfullyestablished.
1. Closetheinvertercover:Attachtheinvertercoverandsecureitbytighteningthescrews
withatorqueof9.0N*m/6.6lb.*ft.Forpropersealing,firsttightenthecornerscrews
andthenthetwocentralscrews(seealsoFigure 30).
2. TurnONtheACtotheinverterbyturningONthecircuitbreakeronthemaindistribution
panelandturningontheSafetySwitch.
3. WaitfortheinvertertoconnecttotheSolarEdgemonitoringportal.Thismaytakeupto
twominutes.
AstatusscreensimilartothefollowingappearsontheLCDpanel:
V a c [ V ] V d c [ V ] P a c [ w ]
2 4 0 . 7 1 4 . 1 0 . 0
P _ O K : 0 0 0 / 0 0 0 < S _ O K >
- - - - - - - - - - - - - - - O F F
S_OK:IndicatesthattheconnectiontotheSolarEdgemonitoringportalissuccessful.IfS_OK
isnotdisplayed,refertoErrors and Troubleshooting on page 83.
SolarEdge-Installation Guide MAN-01-00002-4.0
82
Verifying the Connection