P400 Installation

2. SelectServer tosetwhichcommunicationmethodisusedtocommunicatebetween
devicesandtheSolarEdgemonitoringportal.RefertoSetting Up Communicationonpage
71forafulldescriptionofthesecommunicationoptions.
NOTE
The Server menu shows only the communication options installed in the inverter.
ThefollowingshowsahierarchicaltreeofthemenuoptionsintheCommunication menu.
Fordetailedinformationaboutalltheconfigurationoptions,refertothe Communication
Options Application Note,availableontheSolarEdgewebsiteat
http://www.solaredge.us/files/pdfs/solaredge-communication_options_application_note_
v2_250_and_above.pdf.
Communication
1
:
S e r v e r < L A N >
L A N C o n f
R S 4 8 5 – 1 C o n f < S >
Z i g B e e C o n f < S >
W i - F i C o n f < N / A >
R S 2 3 2 C o n f
C e l l u l a r
G P I O C o n f < M T R >
Server:
L A N
R S 4 8 5
Z i g b e e
C e l l u l a r
R S 2 3 2
N o n e
1
If ZigBee is connected, the Wi-Fi Conf menu is not displayed. If ZigBee is not connected, ZigBee Conf and Wi-Fi Conf are
both displayed with <N/A> and their menus are not accessible.
Chapter 6: User Interface
SolarEdge-Installation Guide MAN-01-00002-4.0
59