P400 Installation


3. PresstheEnterbuttonforatleast5seconds.Thefollowingmessageisdisplayed:
P l e a s e e n t e r
P a s s w o r d
* * * * * * * *
4. UsethethreerightmostinternalLCDuserbuttonstotypeinthefollowingpassword:
12312312.Thefollowingmessageisdisplayed:
C o u n t r y < U S A + >
L a n g u a g e < E n g >
C o m m u n i c a t i o n
P o w e r C o n t r o l
D i s p l a y
M a i n t e n a n c e
I n f o r m a t i o n
TheinverterisnowinSetupmodeandallitsLEDsarelit.Theinverterautomaticallyexits
Setupmodeifnobuttonsarepressedformorethan2minutes.
Thefollowingshowsahierarchicaltreeofthemenuoptions,whicharedescribedin
Configuration Menu Optionsonpage57.Actualmenusmayvaryfromshowndependingon
thefirmwareversionoftheinverter.
Mainmenu:
C o u n t r y < U S A + >
L a n g u a g e < E n g >
C o m m u n i c a t i o n
P o w e r C o n t r o l
D i s p l a y
M a i n t e n a n c e
I n f o r m a t i o n
Country:
U S A +
SolarEdge-Installation Guide MAN-01-00002-4.0
52
Configuring the Inverter Using the Internal LCD User Buttons