Manual

TOP BOTTOM
Step 2 - Installing the Antennae:
The antennae work with the switches to create the “brains” of your Beetlebot. Get your antennae
and two of the 2-56 x 1/4” screws.
Just so you know, “2” refers to the diameter size of bolt, “56” is the number of grooves (per inch),
and the 1/4” is how long it is.
Pick a side of the baseplate to call “the top”. Screw one antenna down to
the hole shown in the picture below until the screw stops going in. Then
back it out 1/4 of a turn so the antenna swivels loosely, but won’t
pop the “S” curve out of the slot.
Add the other antenna to the other side. When you are done,
you should have two floppy antennae mounted to
your baseplate!
This is the
screw you
need (full-size
shown here)
X 2
6