Manual

Step 1 - Preparing the laser cut baseplate:

Let’s start by making sure our baseplate is ready to go. Being laser-cut, there might be

some small pieces that didn’t fully clear out, so take a close look at each hole to make sure

they are clear. If not, use your thumb to nudge the bits out.

When you are sure all the holes are cleared out, peel off the protective paper mask. The

little black bits can be thrown out.

Step 1a: Press out any bit that might be stuck... Step 1b: ...then peel off the protective paper.

We’ll show you what your project should look like at the end of each step. Not much

here, but the baseplate with nice, clean holes!