Manual

TOP BOTTOM
13
Step 9 - Plugging in the Main Wire & Switch Harness:
With the antenna switches, these wiring harnesses make up the “smarts” of the
Beetlebot. Simply plug the wires into the positions shown.
The plugs slide onto the switches easily, but will stay firm. If you are not sure if it is
connected right, unplug it and replug it in again. It should “stick” a bit when you try to
pull it out.
The rest of the wire plugs fit in nice and smooth, with no “sticking”.
Note: If you plug the harness in backwards, it will run backwards (cool, but wrong!)