Manual

TOP BOTTOM
10
Step 6 - The Motors and Wheels:
Your motors come with white nubs on the shaft. Push the rubber wheels over the nubs.
Find your two motors and the “double-sided sticky-tape” (”DSST”). If you want, cut the
DSST in half to make it fit the motor better.
Find the PLUS SIGN on the back of the motor. You want to put the DSST on the same side
of the motor that the plus is. Peel off the DSST protective tape, and stick it to the motor.
Peel off the other piece of protective tape, and stick the motors on the motor mounts as
shown below on the picture. Make the back of the motor align with the bend on the
motor mount, so when you put it down, the Beetlebot sits on the two wheels and NOT the
battery pack.
6a: Push the rubber wheels
onto the motor nubs
6b: Find the plus signs on the
motors, and stick the DSST on
the side nearest the plus
Note where
plus sign is!
Make it match!
6c: Before you stick down the
motor, find the plus signs, and
match this photo. Then stick the
motors onto the mounts!
Plus
signs!
TOP