Documentation

1 - Herbie PCB (3 Pieces) 2 - Rubber Tires
1 - Herbie Battery Board 1 - 22µF Capacitor
1 - LM386 1 - Paperclip
1 - 8-Pin IC Socket (for the LM386) 1 - Nose Bead
2 - Infrared Photodiodes 2 - 30cm (12”) Whisker Wires
1 - 3904 Transistor 1 - 1/4” length of 1/8” dia. heat shrink
1 - Relay
1 - Power Switch Optional Parts:
1 - Tail Spring Sensor 1 - 9V Battery (well, you will need one, right?)
1 - 4.7k Resistor (Yellow / Purple / Red) 1 - IR LED
1 - Double Sided Sticky Tape (”DSST”) 1 - 150 ohm Resistor (Brown / Green / Brown)
2 - Motors with Hubs
We strongly suggest you inventory the parts in your kit to make sure you have all the parts listed. If anything is missing, contact Solarbotics Ltd. for
replacement parts information.
“SOLARBOTICS” is a trademark of Solarbotics Ltd. Reg. CIPO / USPTO.
Disclaimer of Liability
Solarbotics Ltd. is not responsible for any special, incidental, or consequential damages resulting from any breach of warranty, or under any legal theory,
including lost profits, downtime, good-will, damage to or replacement of equipment or property, and any costs or recovering of any material or goods
associated with the assembly or use of this product. Solarbotics Ltd. reserves the right to make substitutions and changes to this product without prior
notice.
Tools:
Basic Soldering Equipment Scissors / Knife
Eye protection (goggles) Masking Tape
Needle-nose pliers Flashlight or IR Remote control (for testing)
Fine snips
Medium/heavy duty snips
Parts:
Whisker Wire
Herbie PCB
Battery Connector
Relay
Nose Bead22µF Capacitor
4.7k
Resistor
3-legged Iguanodon
(whups, we mean paperclip...)
3904
Transistor
Power Switch
IR Sensors
Rubber Tires
Motors
LM386
8-Pin IC
Carrier
Tail Sensor
Spring
Double-sided
Sticky Tape
Spare solid-core
wire
Heat Shrink
Tubing
Optional
IR LED
Optional
150 ohm Resistor
Solarbotics Herbie the Mousebot