Manual

Build the Box: The box is built using “T-Slot” construction, which is a pretty common
technique used with laser-cut profiles (see http://bit.ly/T-slot_laser for more history of this
method).
Connect the parts together as shown on the parts maps. All parts are located near their mates,
and between that and the photos, you should have no problem getting them all connected.
Place a nut in the top part of the “t”. You might find it convenient to use a little tape on to hold
the nut in place during assembly, but we tried to design the slots so they would hold the nuts
snuggly. The slot will only take the nut when it’s inserted squarely in, so don’t force it. If you’re
having trouble getting them in, try inserting the nut from the other side.
/
The notches in the acrylic are aligned so the mating parts nests together. Put them together,
and put the 4-40 bolt into the hole and thread it into the nut. Be careful when tightening the
screw! It doesn’t need much torque to make it sit
tight - just a ½ turn more than finger-tight is fine!
Do NOT over-torque nuts/bolts. Use only hand-
screwdriver (not powered) to assemble.
We offer a “cracked part” warrantee where we will
send out a free replacement part of the piece broken
during assembly (send photo of part, if possible).
1. Insert nut
2. Place 2nd part, insert bolt, and tighten
3. All secure & tight!