User Guide

5
Using the control unit
After the element has been connected to the power supply, the symbol “--” will flash in the upper area
of the display. This indicates that the element is receiving power and ready for use. The element is in
the standby position.
Pressing the power button will switch the element from stand by to “On”.
The last temperature setting used will appear on the display.
If the Sun symbol flashes, this means the current temperature is different to the target
temperature.
If the current temperature is lower than the target temperature, the sun will flash slowly and the
element will start to heat.
If the sun is not flashing, the target temperature has been reached.
This is an input button with 4 functions, 2H, 4H, PC, RC.
By repeatedly pressing the button you move through each function:
• 2H (Boost)= The device works at maximum power for 2 hours and will return to the previous mode.
• 4H (Boost)= The device works at maximum power for 4 hours.
Upon completion of the boost term the device will return to the previously selected temperature.
• PC = APP mode to control with the APP
• RC = Program mode from the remote control
The hourglass indicates a timed program has expired.
Attention: If the element is disconnected from the power supply, the settings will be lost. However, settings from the app
and remote control are retained.
Change the target temperature in 5°C increments.
WiFi App and control
Download the App
• Download and install the “SolAire WiFi IQ” APP from either the Android Play Store or the iOS APP Store
• Now you will need to create an account. If you already have an account, sign into the existing account.
An account can be registered under either a phone number or email address. If you enter a phone number, a verification number will
be sent to your phone: enter this number to verify, then create a password. If you enter your email address, you’ll just need to create a
password.