User Guide

11
Setting the timer using the remote control
Press the days 1-7 will be displayed. A cursor will flash under the 1st day of the week (Monday).
If you’d like to programme several days to be the same, press the + button. The cursor will flash quickly,
indicating the above day has been selected. Now press to move to the next day. The cursor will
move to 2 (for Tuesday). To skip a day, press without pressing +.
After pressing the button for the last day of the week, the system will go to the data entry screen.
The selected days will appear on the display. The “01” at the top of the display indicates that period 1 is
being set. Up to 4 periods can be set each day.
The word “Start” will appear with a time flashing underneath. This time is when the radiator will switch on.
It can be changed by pressing the + or – buttons.
Once the time has been selected, press the button and the word “Stop” will appear. (Stop is when the
element will stop heating). Now enter the required time in the same way. Then and press the button
again.
On the top edge of the display, the heated towel rail symbol is displayed. Press the + or - button to
switch between radiator or room temperature control. The symbol shown on the display represents the
selected option. Confirm the selection by pressing the button.
Now the temperature will flash. Use the + and - buttons to select the desired temperature, and then
press the button to confirm.
Available temperatures are 30-70°C (in 5°C increments) for the radiator temperature, and 15-35°C (in
1°C increments) for the room temperature.
Now, the start time will flash on the display and “02” will be shown. This indicates the 2nd period is being
set.
Repeat these steps to set periods 1-4.
If you do not wish to enter 4 periods, press the button for the last entered programme and then
press the button as soon as the new number for the next programme appears. This will end the
programme entry. The word will “good” appear and the device switches to the standard display.
Please note: if multiple days were selected, the programme will be applied to all of these days.
• Select which day(s) of the week are being programmed.
• It is possible to programme a single or multiple days.
• Up to 4 different periods per day can be defined.