Read the entire installation manual before installing a Accolade WARNING! STOP DO NOT WORK ON ROOF IF SURFACE 18 WET, FROSTED, ICE OR SNOW COVERED. USE LADDERS SAFELY USE HAND & EYE PROTECTION WHEN WORKING WITH POWER TOOLS USE EXTREME CAUTION TO AVOID CONTACT WITH POWER LINES. CONTACT WITH POWER LINES, ELECTRIC LIGHTS OR POWER CIRCUITS MAY BE FATAL installation of this product shooed be attempted only by individuals skilled in the use of the tools and equipment necessary for installation.
General Wiring Installation Instructions Acceptable UL recognized components are found In UL Report # 3171411PRT-002 Remove any necessary knockouts before securing the Accolade to the roof or other surface. Follow the mounting instructions page 4 Install components onto the din tall and lock In place. When combining, secure the bus bar to the fuse holders or breakers. Install neutral mounted power black on din rail where designated PV neutral or negative and lack in place.
Accolade Installation Instructions DO NOT PROCEED WITH INSTALLATION UNTIL YOU HAVE READ ENTIRE INSTRUCTIONS INCLUDING WARNINGS Figure 1 + Determine the location for the Accolade on the roof surface. + Use the template from the bottom of the Accolade carton to trace the Accolade on the shingles. Figure 2 « Use a pry bar to loosen the shingles, then remove any nails that would interfere with the Accolade flashing. *The flashing will slide beneath the shingles.
Typical Accolade Combiner Features « Typical Accolade Combiner Features «Stamped seamless galvanized steel or Stainless * Powder coated surfaces (1,100 salt spray hours) * Models available Grey, black or stainless steel * Flashes into the roof deck Two, five or single position ground lug 8” din ral installed 5 Roof deck knockouts (3) (1) @ .
Common Component & Kit Examples 2 Pole AC Breaker Power Distribution Block 1 Pole Fuse Holder Positive Bus Bar — Midget Fuse Terminal blocks, available in red, Grey or black Rail Stop End Plate ‘4mm, Sm, 20mm Accolade 0799-2 with DC Combiner Kit Accolade 0799-5 with DC Pastiness Kit *Salado enclosures include din rail and ground blocks. All other internal parts are sold separately.
Typical DC Wiring Schematic Warranty Information ‘Warranty repairs must conform to warranty terms. As with all manufactured devices, replacement may be needed due to damage, unauthorized use, or defect. Equipment must be Installed according to the Instructions and manuals provided. Products returned must be packaged, properly addressed and shipped prepaid.
