Operation Manual

14
• Clean and dry all parts. We recommend cleaning the valve with a stream of warm water.
After cleaning it, dry it and assemble all parts in the correct order.
• Do not use the safety valve if the piston inside does not move correctly, even after cle-
aning. Contact your distributor to have the valve cleaned by a professional or to replace
it.
(Fig. G)
NOTE:
If you are not sure of how to follow the assembly and disassembly instructions before and
after cleaning them, do not clean the regulation and safety valves. Contact the authorised
technical assistance services for assistance.
SPECIFIC INSTRUCTIONS - WHAT TO DO WHEN:
Steam escapes between the lid and cooker.
It is possible that:
• The cooker is not closed correctly. Open it and close it again properly.
• The rubber joint is dirty or deteriorated. Clean or replace it.
No steam coming through the pressure adjustment valve.
It is possible that:
• The cooker is not closed correctly. Repeat the closing operation.
• The pressure adjustment valve is dirty. Clean it following the instructions.
• Not enough liquid in the cooker. Check the amount of liquid.
• The rubber joint is not placed correctly or it is deteriorated. Clean or replace it. We recom-
mend changing the rubber joint once a year.
Too much steam coming through the pressure adjustment valve.
It is possible that:
• Too much heat. Reduce it.
• The pressure adjustment valve is dirty. Clean it following the instructions.
VERY IMPORTANT NOTE
The natural use of the cooker causes the different parts to become worn. Contact our
Technical Assistance Service to replace them. If you have any doubts on the efficiency of
the safety devices, do not use the pressure cooker, contact one of our authorised technical
assistance services.
When replacing parts of the cooker, always use original spare parts.
ENGLISH