Specifications

DESCRIPTION OF THE APPLIANCE 11
en
DESCRIPTION OF THE APPLIANCE
1 Main body
2LED light
3 ON/OFF switch
4 Telescopic handle
5 Handle release button
6 Air outlet grille
7 Charging connector port
8 Electrodes
9 Suction outlet
10 Dust collector
11 Dust collector release button
12 Filter case
13 Filter
14 Filter bracket
15 Telescopic pole
16 Air inlet
17 Upholstery nozzle
18 Suction nozzle for grooves and corners
19 Multipurpose brush
20 Multipurpose brush release button
21 Rotating brush
22 Rotating brush release button
23 Brush cover
24 Charger
CHARGING THE BATTERIES
) Any repair or change of batteries must be carried out by an Authorised Technical
Service.
) During the charging process, the charger heats up slightly. This is normal, unless it
heats up excessively.
n Only use the supplied charger, never use a different one.
1 Place the switch (3) in the OFF position.
2 Connect the charger cable (24) to the charging connector port (7). (fig. 1)
3 Plug the charger into the mains.
, The red charge indicator (2) will flash while it is charging and will stop flashing but
remain lit when the appliance is fully charged.
, The charge time is around 16 hours and the batteries will run for 14 minutes. An
electronic device will disconnect the batteries after 15 minutes to increase their life.
Before you use the appliance for the first time, charge the batteries for 24 hours.
, If after a 16-hour charge the batteries only last for 1 or 2 minutes, please contact an
Authorised Technical Service to replace the batteries.
4 Once the charge is complete, unplug the charger from the mains. Keep it in a safe place
for future use.
The appliance is ready for use.
RECOMMENDATIONS TO INCREASE THE BATTERY LIFE
• Do not leave the charger connected for long periods of time. Disconnect it once you
have finished charging the batteries.
• Use the broom until the electronic device has disconnected the appliance and recharge
the battery fully.