Quick Start Guide

08
09
PRIVACY BUTTONS
To ensure your absolute privacy we’ve designed two hardware
switches into the HELLO 2 to physically connect and disconnect the
camera and microphones from the system. This will guarantee your
privacy with no hacking risks.
Note: To ensure these buttons are un-hackable, their function cannot be controlled
from the remote or any software.
Mute Video
Mute Audio
1. Ensure that the batteries are inserted into the remote control.
2. Turn off HELLO 2 by unplugging it and keep the remote control
close to the device.
3. Press and hold the back button and OK button on the remote.
The red LED on the front of the remote will blink intermittently. After that
release the buttons.
4. Plug-in HELLO 2 again, wait for it to successfully boot. After a few seconds,
the red LED on the remote will flash again with changed frequency to indicate
the pairing process finished successfully.
HOW TO PAIR A NEW REMOTE CONTROL
Process:
The remote control comes pre-paired with the device in the box. It is
not recommended that you use this feature if you don’t have any
pairing issues with the remote. This feature will be needed only if you
lose your remote and you get a new one.
Press and Hold