0/10™ & 20/20™ Solar LED Lighting Systems Factory Partially Assembled Edition Installation Manual MKTG-IM-20/20PA-001-0614
Installation Manual | 20/20 Light Important Notes and Warnings This installation and instruction manual provides installation instructions for the Sol 20/20 Series solar LED lighting systems. The entire contents of this manual should be thoroughly reviewed and understood prior to installing this equipment. Do not discard this manual, as it contains complete installation instructions. To insure proper operation of this equipment, it is important that the equipment be utilized for its intended use.
Installation Manual | 20/20 Light Parts Provided Solar Panels (2 or 3) Pole Mounting Pad Template Fixture Assembly 10/10™ LED or 20/20™ LED Battery Box Battery Box High Wind Support for Top of Pole Mount Bracket (supplied when required) Aluminum Pole Assembly Tenon Adaptor Controller Top of Pole Mount Bracket HARDWARE extra hardware may be supplied with your order Front Tenon Shield Back Tenon Shield Endplates (2) Cable Straps, Wire Nuts, Wire Ties, and Connector Caps High Wind Adaptor Kit scre
Installation Manual | 20/20 Light 1.0 Positioning the Light 2.0 Preparing the Pad a Template Fastener Set D (4) 4 rev.
Installation Manual | 20/20 Light 3.0 Securing the Pole to the Pad a Fastener Set D (4) Actual nut washer count may vary b Lock 5 rev.
Installation Manual | 20/20 Light 4.0 Assembling 4.1 Attach High Wind Bracket Supports to Tenon Adaptor Bracket (if provided), otherwise skip to step 4.2 a High Wind Fastener Set - Base (6) Aluminum Spacer (2) b High Wind Hex Head Bolt - Center (6) 6 rev.
Installation Manual | 20/20 Light 4.2 Attach the Tenon Adaptor Bracket to Panel Mount a Fastener Set A (6) b c Fastener Set A (4) Center 7 rev.
Installation Manual | 20/20 Light 4.2 Attach the Tenon Adaptor, Tilted to Your Latitude a b Fastener Set C (2) 8 rev.
Installation Manual | 20/20 Light 4.3 Mount the Solar Panel Assembly on the Pole a Do Not Exceed Working Load Limit b 9 rev.
Installation Manual | 20/20 Light c d Fastener Set B (1) 10 rev.
Installation Manual | 20/20 Light 4.4 Mount the Light Fixture on the Pole a b c 11 rev.
Installation Manual | 20/20 Light 4.5 Route, Cut, and Connect the Light Fixture Cable a 5/8 inch drill bit b 12 rev.
Installation Manual | 20/20 Light c d e 13 rev.
Installation Manual | 20/20 Light 4.6 Mount the Battery Boxes a Fastener Set A (6) b c 14 rev.
Installation Manual | 20/20 Light 4.7 Install the Controller a 4.8 Install the Batteries - if using Deka® Brand see Battery Terminal Addendum sheet a b 15 rev.
Installation Manual | 20/20 Light c 2 Batteries 3 Batteries 4.9 4 Batteries Connect the Cables a Solar Panels Light Fixture Green Wire (to Ground) Wiring Harness EternO® 4 Controller Fuse Batteries 16 rev.
Installation Manual | 20/20 Light 4.10 Arrange and Secure the Cables a cap 4.11 Test a 4.12 Install the Battery Box Covers a Fastener Set C (4) 17 rev.
Installation Manual | 20/20 Light 4.13 Install the Shields a Fastener Set C (2) b Fastener Set C (2) 4.14 Install the End Plates a Fastener Set C (4) 18 rev.
In-Warranty Service Instructions A Returned Merchandise Authorization (RMA) number must be obtained from Sol Inc. before equipment can be returned for repair or replacement under warranty.
