Instructions / Assembly

EOS

INSTALLATION

OOLS

Tools are not included in the kit. The items listed below are available at most local

hardware stores. Installer must furnish the following items:

Required

Suggested

 Tape Measure  Ladder

 Drill Motor/Driver  Level

 #3 Phillips Driver Bit  Alcohol Cleaner

 1/8" Drill Bit *  Cleaning Rag

 Pencil or marker

 Small tube of urethane based sealant

NOTE: * Additional drill sizes may be required for some installations. Refer to page 8 for

examples.

OMPONENT

HECKLIST

NPACKING

1. Remove the awning from the

shipping carton.

2. Lay the awning face down on a

non-abrasive padded surface.

3. Remove the mounting plate

from the back of the awning.

3.1. Press in the two latches

on the bottom of the

cassette to release the

mounting plate.

3.2. Rotate the plate up and

out from the awning

cassette.

3.3. Set plate aside.

Mounting Plate

(attached to awning)

Awning Complete

#12 x 1 1/2" Flat Head

Wood Screws (qty: 10)

SoL006

Wall Anchors (qty: 10)

Rotate and Lift

Plate from Case

Press In

to Release

Plate Latches

SoL001