Instructions / Assembly

SOL-LUX
16
AWNING CARE
Maintaining an EOS Awning is easy. Just follow these basic steps:
 Always operate the awning according to the instructions.
 Keep the awning fabric and solar panel clean.
F ABRIC C ARE
NOTICE Do not use oil based cleaners or any caustic, granulated,
or abrasive type cleaners on your EOS product.
1. One of the best ways to keep the fabric looking good and to delay the need
for deep or vigorous cleanings is to hose fabrics off on a monthly basis with
clear water. This practice will help prevent dirt from becoming deeply
imbedded in the fabric. In most environments, a thorough cleaning will be
needed every two to three years.
2. When it is time for a thorough cleaning, the fabric can be cleaned while still on the
awning frame. Use a stiff brush and warm water with soap.
3. When cleaning the fabric, it is important to observe the following:
 Always use a natural soap, never detergent.
 Water should be cold to lukewarm, never more than 100F.
 Air-dry only. Never apply heat to the fabric.
 Always allow the fabric to dry thoroughly before rolling up the awning.
M ILDEW
Mildew is a fungus growth that looks like dirt. Under ordinary conditions, mildew
will not appear. The Sunbrella Marine Acrylic Fabrics used in the Eos have
additives that resist mold and mildew. However, in areas where high
temperature and humidity are common, mildew can be a problem and require the
fabric to be washed more frequently. Thoroughly rinse the fabric with clean
water and allow to air dry completely before rolling up the awning. In the event of
any mold and/or mildew growth, our Sunbrella fabrics are bleach cleanable to
remove any stains. This will not fade the fabric as the woven fibers of Sunbrella
fabric are individually dyed. If fabric does become wet and the awning is
retracted, it should be extended so the fabric can breathe and dry.
A RM C ARE
The best method of keeping the awning support arms operating smoothly is to clean
them. Dirt and debris can cause the arms to not pivot easily. Periodically wash the
arms with running water (i.e. a hose). If the joints do not move easily, lightly spray the
joints with a dry silicone lubricant after the arms have been cleaned and dried
thoroughly.