Instructions / Assembly

SOL-LUX
14
BATTERY
The EOS uses a rechargeable 9.6V Lithium Iron Phosphate Batteries (LiFePO
4
)
battery pack.
The battery is charged by the integrated solar panel located on the top right of
the cassette. The battery comes partially charged and ready for use. It will reach
full charge within 2 to 5 days depending on the amount of use and the amount of
sunlight the solar panel receives. Charging time will be slower during cloudy or
overcast conditions. The battery will continue to charge from sunlight as long as
the battery temperature remains within the safe charging range.
Important Note: If a low battery condition is shown (refer to page 13) or displayed in
the app, the battery must be charged by placing the solar panel of the awning in direct
sunlight. An auxiliary solar panel may be necessary depending on the location of the
awning and the ability for the integrated solar panel to receive direct sunlight (refer to
page 5). Failure to charge the battery within 300 days of notification will result in a dead
battery that can no longer be charged and must be replaced for continued operation.
CAUTION The battery used in this product may present a risk of
fire or chemical burn if mistreated.
 Do not attempt to disassemble or destroy the battery. There are no
user serviceable parts.
 Do not incinerate or dispose of in fire.
 Replace the battery with SOL-LUX battery part # 012687-001 only.
This product contains a Lithium Iron Phosphate (LiFePO
4
) battery.
To preserve natural resources, please recycle or dispose of batteries
properly. Consult your local waste authority for information
regarding available recycling and/or disposal options.
R EMOVING THE BATTERY
1. Remove the awning from the
mounting plate (see page 15).
2. Lay the awning face down on
a padded surface.
3. Lift the locking tab and slide
the battery to the right until the
connector clears the housing.
4. Press in the two (2) retaining
tabs and rotate the battery out
of the cassette.
NOTES:
 When the battery is disconnected, the awning will be reset. After the battery
is reconnected and the awning is correctly mounted the awning will perform
a calibration (refer to page 10).
 The SOL-LUX Mobile App will remain paired to your smartphone or tablet if
previously paired before the battery was disconnected.
 Scheduled events (Daily Schedule and Vacation mode) are not saved and
must be entered when the battery is reconnected.
 The autonomous functions may be activated through the Service screen of
the SOL-LUX Mobile App.
Lift Locking
Tab Up
Slide Battery
Press Retaining Tabs In
SoL012
Connector (ref)