Instructions / Assembly

EOS
11
A WNING F AILED TO C ALIBRATE
Calibration may fail because of the following reasons:
 Awning is not level and/or plumb. During calibration, the EOS checks its
position. If the awning tries to calibrate in an incorrect position, calibration
will fail. Remount the awning.
 Battery charge is too low. Allow the battery to charge with direct sunlight
shining on the E
OS solar panel..
 Battery or awning temperature is out of operating range. As a safety
precaution, when the internal battery or awning temperature is outside the
safe operating range, the awning will not calibrate until the temperature is
within range.
 Obstruction in lead rail path. If an obstacle stops the awning from opening
fully, the calibration will fail. Clear the obstruction.
 High wind detected. If wind (or motion) is detected during the calibration cycle,
the awning will retract and retry the calibration sequence after a 24 hour delay.
Briefly disconnecting and the reconnecting the battery will reset this delay to 1
minute. Alternately, the Sol-Lux Mobile App can be used to initiate a calibration.