Data Sheet

The light brackets are equipped with a common plus. This
means that the plus connection leads directly to the plus on the
model. The minus on the relevant LED leads to the switch
module output (e.g. ALF, or RX47 P-Output). Between 3.7V
and 4.8V, no other series resistors are necessary.
To wire the module, we recommend enameled copper wire or
fine stranded wire. To do this, the solder pads on the light
bracket are initially tinned using a soldering iron. The stranded
wire is stripped and is also tinned. If using enameled copper
wire, this is stripped whilst the end of the wire is held against a
soldering iron that is moistened with solder. After a few
seconds, the enamel melts and the wire tip appears slightly
silvery.
The wire or stranded wire is now shortened and soldered onto
the respective solder pad without the need for any additional
solder.
DATA SHEET
For the front lighting of a 1:87 HGV
Pre-assembled light bracket for 1:87 HGV / Front Art.no. 93325
www.1zu87modellbau.de
Alterations and errors excepted / Status January 2018 / Christian Reply
©
SOL-EXPERT
group
group
Specifications:
Dimensions
Example circuit:Light bracket 93325:
Light bracket 93326:
Art.no. 93326
Front side 93325
Reverse side 93325
Front side 93326
Reverse side 93326
93325
93326
93325 93326
Current
White LED 0.8 mA 0.5 mA
Yellow LED 2.5 mA 2.5 mA
Red LED brake light --- 4 mA
Red LED rear light --- 2.5 mA
3 x 7.25 mm (H x W) 3 x 11.8 mm (H x W)
Light minus
Common plus
Indicator minus
Reversing light minus
Brake light minus
Rear light minus
Indicator minus
Common plus
L
LB
RB
L
ight
BL: Blinker links
Ru1: Rundumlicht 1
Licht:
BR: Blinker rechts
RU2:Rundumlicht 2
SOL-EXPERT group
Dept. 1zu87modellbau.de
Managing Director: Christian Repky
Mehlisstrasse 19
88255 Baindt
Tel.: 07502 - 941150
Fax: 07502 - 94115-99
www.sol-expert-group.de
[e-mail]
L
Left blinker
Round light 1
Light
Right blinker
Round light 2
a
a =
b
b =
c
c =
d
d =
e
e =