Instructions

Push 2 M2 x 10 mm
screws through
the back piece
Inscription "ON - OFF" should be at the bottom
Push cables ( and black) into red
the centre and right soldering eyes.
Pass the connection cable through the whole on the
back, until the part of the cable that is inside measues
approx. 10cm
Solder cable wires individually to the circuit board.
Pay attention to the colours of the cables. Begin with the red
wire, then the white, then the yellow.
Put a cable tie around the cable, and pull it very
tight (tension relief). Cut off the remaining cable
with side cutters.
Solder the battery clip cable to the circuit board.
Pay attention to the colours of the cables!
Secure and
screw in with
2 M2 nuts
View from the side
Mount
switch
Solder the cables to the eyes
red white yellow
black red
Construction of case back
Cabling the case
6
7
Solder the switch cable on to the
circuit board.
Thread the speaker cables through
the circuit board
compartment
A
B C
D E
F
A
B
C
D
E
F
ON OFF
1 x
C