Datasheet
厦门宝龙工业股份有限公司
XIAMEN POWERLONG INDUSTRY JOINT-STOCK CO., LTD
Model:PL905293F/3.2V Doc No:PQ-AR&D-SPC-L612 Ver:00 Page 4 of 9
6.6
Charge
retentionand
recovery
capacity
荷电保持能力
及恢复容量
Afterstandardcharging,At20℃±5℃ambient temperature,
the electrical core open shelved after 28d, at 23±2℃
ambient temperature to 0.2
I
t
A voltage discharge to the
deadline, record the discharge time, and then the
standard charge,at23 ± 2 ℃ ambient temperature to
0.2
I
t
A discharge to the deadline voltage, discharge time
record.
标准充电后,在20℃±5℃的环境温度下,电芯开路搁
置28d后,在23℃±2℃的环境温度下以0.2
I
t
A放电至终
止电压,记录放电时间,然后再标准充电后,在23℃
±2℃的环境温度下以0.2
I
t
A放电至终止电压,记录放
电时间。
时间A≥4.25h
时间B≥4.50h
7. Environment Performance 环境性能
No
Item项目 TestMethodsandCondition 测试方法和条件 Criteria 标准
7.1
Vibrationtest
振动测试
Afterstandardcharging,thebatteryisinstalledonthe
shakingtable,cannotmakethecelldeformation.The
sinusoidalvibration,andthelogarithmicsweepmethod
in15minfromthe7Hzsweepto200Hzandreturnto
7Hz.The3directionvibrationalongthesample
perpendiculartoeach
other(onedirectionmustbe
positiveandnegativepoleisperpendicularwiththe
sample),eachdirectionaccordingtothelogarithmic
frequencysweepmoderepeat12times,vibration3h.
Logarithmicsweepmethodisasfollows:7Hz~18Hzkeep
9.8m/s
2
peakacceleration.Theamplitudein0.8mm
(displacement106mm)untilthepeakacceleration
reaches78.4m/s
2
(frequencyofabout50Hz).Keepthe
growthpeakaccelerationuntilthefrequencyof78.4m/
s
2
to200Hz.Attheendoftheappearanceofthecelland
voltage
.
标准充电后,将电池安装在振动台上,不可使电池变
形。采用正弦波进行振动,并以对数扫频方式在15min
内从7Hz扫频到200Hz并返回到7Hz。振动沿样品互相垂
直的3个方向(其中一个方向必须与样品正负极所在平
面垂直)进行,每个方向按上述对数扫频方式重复12
次,振动3h。
对数扫频方式如下:7Hz~18Hz保持9.8m/s
2
的峰值加速
度。将振幅保持在0.8mm(位移为1.6mm)直至峰值加
速度达到78.4m/s
2
(频率约为50Hz)。保持78.4m/s
2
的峰值加速度直到频率增长到200Hz。 结束后观察电
池外观及电压。
Noleakage,no
venting,no
rupture,nofire,no
explosion,
Theopencircuit
voltageofnotless
than90%ofthe
initialvoltage
不泄漏,不泄气,
不破裂,不起火,
不瀑炸,开路电压
不低于90%初始电
压










