Datasheet

厦门宝龙工业股份有限公司
XIAMEN POWERLONG INDUSTRY JOINT-STOCK CO., LTD
Model：PL905293F/3.2V Doc No：PQ-AR&D-SPC-L612 Ver：00 Page 2 of 9
3.13
InitialImpedance 初始内阻 ≤60mΩ
3.65V,AC1KHzmeasured
3.14
Weight 重量
Approx73g
3.15 Operatingtemperature 工作温度
Charging 充电：0℃~45℃
Discharging 放电：‐10℃~60℃
4. Appearance 产品外观
Thereshallbenosuchdefectasscratch,flaw,crack,rust,leakage,whichmayadverselyaff ect
commercialvalueofbattery.
电池外表面清洁，无电解液泄漏，无明显的划痕及机械损伤，无变形，无影响电池价值的其
它外观缺陷。
5. Test Requirement 测试要求
5.1. Standard test condition 标准测试条件
Test shouldbeconductedwithnewbatterieswithinonemonthaftershipmentfromourfactoryand
thecellsshallnotbecycledmorethanfivetimesbeforethetest.Unlessotherwisedefinedtestand
measurementshallbedoneunderthiscondition:
测试电池必须是本公司出厂时间不超过一个月的新电池，且未进行过五次以上充放电循环。除
非另有规定，本规格书中的各项测试应在以下条件下进行：
Temperature 温度：20℃±5℃
Relative Humidity 相对湿度：不大于 75%
Atmospheric Pressure 大气压：86kPa~106kPa
5.2. Measurement apparatus测试设备要求：
1) Voltage measurement accuracy of instruments should be within±0.5%.
测量电压的仪表准确度应不低于±0.5%.
2) Current measurement accuracy of instruments should be within±0.5%.
测量电流的仪表准确度应不低于±0.5%.
3) Time measurement accuracy of instruments should be within±0.1%.
测量时间用的仪表准确度应不低于±0.1%.
4) Temperature measurement accuracy of instruments should be within±0.5℃.
测量温度的仪表准确度应不低于±0.5℃.
5) Current adjustable constant current source, in the process of constant current charge or discharge, the
relative change of the current should be within±1%.
恒流源的电流可调,在恒流充电或放电的过程中,其电流的相对变化应在±1%范围内.
6) The constant-voltage source voltage is adjustable, in the process of constant voltage charging, the
voltage variation shall be within±1%.
恒压源的电压可调,在恒压充电过程中,其电压变化应在±1%范围内.
5.3. Standard charging method 标准充电方法
At 23℃±2℃, with 0.2 I
t
A constant current charge to 3.65V, then 3.65V constant voltage to the
current 0.05 I
t
A or less, the maximum charging time is not more than 8h.
在 23℃±2℃，以 0.2 I
t
A 恒流充电至 3.65V，再 3.65V 恒压充电至电流 0.05 I
t
A 或更小,最长充电
时间不大于 8h。

