Instructions
1 x
Tighten the buttons's nuts with
the wooden tool
B
M2 x
10 mm
2 x
1 x
Assemble the switch
C
2 x M2
D
Solder the two red cables with the switch
and remove the ends of the wires with
the side cutters.
2 x
E
Tighten the screws
Unscrew the nuts
The assembly kit for the torch with morse code feature
General: This soldering assembly kit should
provide an easy introduction to the basics of
soldering. It is perfectly suited for teaching how
to solder in schools and workshops.
As well as this, the torch assembly
kit can be used at summer camps,
on summer courses and for other
activities to help teach kids
how to solder.
Instructions for protecting the environment:
General: Please take the electrical components to a
certified waste disposal site when they cease to
function. This ensures that the components are
disposed of according to legal guidelines. You can
actively ensure that the environment is protected by
following the regulations in place.
Battery regulations:
You have purchased a battery-operated product from
us. The service life of the battery is limited and must
therefore be replaced regularly. Old batteries do not
belong in the domestic waste.
Consumers are legally obliged to bring batteries to an
appropriate collection point for disposal. Old batteries
contain valuable raw materials which can be recycled.
You can also send your used batteries to:
SOL-EXPERT group, Mehlisstrasse 19, 88225 Baindt.
Parts list:
Features of the torch
If the kit has finished being soldered, then it can be
used as a torch. By inserting an extra button, morse
code can be transmitted with the torch.
The morse code alphabet can be found in the
instructions. If the battery is empty, it can be replaced
by the same type of battery.
Part Components Number
1 wood casing with tool, 8-parts 1
2 Acrylic cover for the casing 1
3 LED white, 5 mm 1
4 LED holder 1
5 Resistor 330 Ohm 1
6 Red cable 3
7 9 V battery 6F22 1
8 Terminal post for 9 V battery 1
9 Button 1
10 Switch 1
11 Screws M2 x 10 2
12 Nuts M2 2
13 Elastic band 32 x 3 x 1.2 mm 2
Check the parts list -
is everything there??
1 x
F
G
Lead one cable from the switch to the button
and solder it in the same loop of the button with
another unconnected red wire. Cut off the ends
of the wires if necessary.
Solder the second cable with the switch with the
red cable of the battery clip to the button's
remaining free loop. Cut off the ends of the
wires if necessary.
above!
above!
1 x
1 x
Assemble the button
A
Unscrew the
spring washer
and nuts
And now you can start with the:
ASSEMBLY INSTRUCTIONS
Wood
Nuts
Spring
washer
1
2
3
!
!