Assembly Instructions

Fig.1: Attach Base Cover (C) to Pole A1（A2）,tighten Base (B) with PoOHA1（A2）by using Bolt ( AA ) and Flat
Washer(BB).
Fig.2: Attach the Long Screen (I) and Short Screen (J) to PoOH A1（A2）with Bolt (CC) and Flat Washer(BB)
Fig.3: Insert Corner top beam (D) into Big Top Connector (F), then attach Hook (H) into Big Top Connector (F).
Fig.4: Fix Corner top beam (D) to PoOH A1（A2）with Bolt( DD) and Flat Washer(BB).
Fig.5: Insert Small Top Pole (G) into Small Top Connector (E).
Fig.6: Put Big Canopy (O) onto the Big Top, do not fully spread, attach Small Top Pole (G) to Corner top
beam (D) by M6 X 35 Bolt (DD), M6 flat Washer (BB) and M6 Nut (EE).
AA
M6X15 Bolt
8 PCS
BB
M6 Flat Washer
8 PCS
FF
5X160MM 7” stake
8 PCS
Hardware Pack 2
Fig.7: Put Small Canopy (p), fully spread
Big Canopy (O), using the Velcro’s to fasten
it to the frame; fix Support Bar (L) to Shelf (K)
by using Bolt (AA) and Flat Washer (BB).