Assembly Instructions

Stand the Table right way up. Place the Table on a LEVEL SURFACE to check for wobbles.
If it wobbles, lift the table some 20cm to 30cm high from the ground.
Keep your feet and toes well away from the drop zone.
Drop the table freely and vertically with all four legs, hitting the ground, at the same time.
This Drop Test will help to ensure that all Bolts and gaps reach full alignment status.
Test again for evenness on a LEVEL SURFACE.
If no wobbles are found, slowly and carefully, turn the Table facedown.
Then, proceed to tighten all Bolts in a sequential manner.
When tightening the Bolts, tighten sequentially.
DO NOT tighten any Bolt fully and then towards the next one.
This could cause the frame to warp. If there are still wobbles, loosen the Bolts and execute the
same drop test.
If the Table is not stable, it could lead to damage to the product.
Step 4
Step 3
Use the Bolt Cap(①) to cover all Bolts（⑦）.
Step 5
Your Table is ready for use.
This Table can only be used on a flat, level surface.
4 OF 5