Installation & Assembly

Step 4. Lay seat panel (part D) upside down on a soft flat surface, such as carpet, as shown below.
Attach side panel (part B) to seat panel (part D) using bolts (part M), flat washers (part O)
NOTE: Please do not fully tighten bolts until unit is fully assembled.
O
x3
Q
x1
M
x3
Step 5. Attach back panel (part F) to arm panel (part E) using long bolts (part N), flat washers
(part O), hex nuts (part P), allen wrench (part Q) and wrench (part R).
NOTE: Please do not fully tighten bolts until unit is fully assembled.
N
x3
O
x6
P
x3
6
Q
x1
and allen wrench (part Q).
R
x1