Installation & Assembly

Step 1. Lay seat panel (part A) upside down on a soft flat surface, such as carpet, as shown below.
Attach side panels (part B) to seat panel (part A) using bolts (part M), flat washers (part O)
NOTE: Please do not fully tighten bolts until unit is fully assembled.
O
x6
Q
x1
M
x6
Step 2. Attach back panel (part C) to seat panel (part A) and side panels (part B) using long bolts
(part N), flat washers (part O), hex nuts (part P), allen wrench (part Q) and wrench (part R).
NOTE: Please fully tighten all bolts at this time.
N
x6
O
x12
P
x6
4
Q
x1
and allen wrench (part Q).
R
x1