Installation & Assembly

Spa Owner’s Manual
- 4 -
IMPORTANT NOTE: DO NOT leave your SPA in direct sunlight for extended periods of time. Doing so may void your warranty. The
SPA has covered insulation foam over the shell and pipe work. If left exposed to direct sunlight the surface temperature can build up
to 200 ℃ causing damage to your SPA. It is suggested that you not only have the hard cover over your SPA while not in use but
also have the SPA in an area which is sheltered from extreme and harsh weather conditions. Leaving the SPA uncovered and
exposed may void your warranty on your SPA and its accessories.
◼ Electrical installation (IMPORTANT ATTENTION):
➢ The power supply should be: 380V/50HZ-60HZ or 220V/50HZ-60HZ. You are advised to apply the 5×6mm2 cable for 380V power or the
3x10mm2 cable for 220V power.
➢ The electrical supply to your new spa will require a dedicated circuit with no other appliances or sockets sharing the power. Electrical
burnout due to incorrect amperage WILL NOT be covered by warranty. Ask for qualified electrician for electrical connection.
➢ Ensure the main power supply has installed high sensitive leakage protectors. Recommend 30mA leakage protectors.
➢ Ensure your new SPA is safely earthing as right figure. Please refer the control system instruction manual before electrical installation.
➢ You are advised to drill a dia. 26mm cable hole on the bottom of one corner skirt that is near the control box as right figure for the cable.
SPA OPERATION:
In order to avoid any misunderstanding or damage on the spas, please follow below procedure carefully before enjoying your
spa.
◼ Filling your SPA:
➢ Before filling your spa, please check and tighten all the live connectors, they may go loose during transportation.
➢ Please check and make sure all the check valves are all in the open position.
➢ Check that the drainage valve is shut off.
➢ Check that all jets are in the open position. Swivel anti-clockwise to turn your jets on.
➢ Fill your SPA with water. Make sure to fill the water through filter area every time in order to prevent air block in the pumps.
➢ Fill water to the line on the water level indicator as the figure which is 4’’ to 6’’ (100 to 150mm) below the top edge of the spa.
Do not overfill as the spa’s water level will rise as each person enters the spa.
NOTE: To avoid any damage to the components, DO NOT fill hot water over 40℃ into your SPA.
The required water level