User's Manual

www.soiltechwireless.com

§ 15.21.

Changes or modifications not expressly approved by the party responsible for

compliance could void the user‘s authority to operate the equipment.

§ 15.105

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one or more of the following

measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

—Consult the dealer or an experienced radio/TV technician for help.

RF Exposure Information (MPE)

This device complies with radio frequency (RF) exposure limits adopted by the Federal

Communications Commission for an uncontrolled environment. This equipment should

be installed and operated to ensure a minimum of 20 cm spacing to any person at all

times.

Disclaimer

Soiltech Wireless Inc (SWI) reserves the right to make changes in specifications and other information contained in this document

without prior notice, and the reader should in all cases consult SWI to determine w hether any such changes have been made. The

information in this publication does not represent a commitment on the part of SWI. SWI shall not be liable for technical or editorial

errors or omissions contained herein; nor for incidental or consequential damages resulting from the furnishing, performance, or use

of this material. SWI disclaims all responsibility for the selection and use of software and/or hardware to achieve intended results.

This document contains proprietary information that is protected by copyright. All rights are reserved. No part of this document may