KBS-54K002 Please scan the below QR code to get the video for easy installation. Email:sofucor_service@163.com Email:sofucorceilingfan@163.com Website: www.sofucorfan.
01 Safety Information 1 Match code 15 Warranty 2 3 Fans Balance Care and cleaning 16 17 4 5 Trouble shooting Three ceiling installation methods Installation procedure Remote control manual Connecting Smart Systems 02 Warning: Kindly turn off the power when connecting cables.
03 2
04 5 9 5 2 9 2 3 9 3 3
05 4
06 Install the blades 1. Remove the nine blade screws on the motor 2. Loosen the two light kit screws pre-locked on the motor and remove the third light kit screw( They will be needed later.) 3. Attach the blades using the nine blade screws and tighten the blade screws 4.
06 Install the light plate 5.Feed the wire plugs through the center hole 6. Wrap keyhole slots around the screws and twist clockwise 7. Insert the third light kit screw, and then tighten all three light kit screws 8.
06 9. Connect the light source with the wires from the motor 10. Insert three light kit screws, and then tighten them Install the downrod 11. Remove the lock pin and the bolt of the base of the downrod 12.
06 13. Remove the hanger ball and bolt 14. Select one downrod and pass all motor wires through the downrod( this side with two holes) 15. Insert the bolt 16.
06 17. Tighten the screws to prevent fan shaking during the operation 18. Put the decorative cover through the downrod 19. Put the canopy cover through the downrod 20.
06 21. Put the hanger ball through the downrod 23. Fix the green ground wire with screw. Align the screw hole and tighten the screw 22. Insert the bolt 24.
06 Install the ceiling bracket for wooden ceiling Is your ceiling different? Check out the guide at the page of 3. 25. Install the ceiling bracket with four self tapping screws 26. Place the downrod ball into the slot in the ceiling bracket.
06 27. Connect the wire from the ceiling fan to the receiver( Red, White and Black wires) 28. Connect the wire from the ceiling fan to the receiver( Red, White and Yellow wires) 29.Use wire connecting nuts to connect the 30.
06 31.Use wire connecting nuts to connect the live wire( black) coming from the receiver and house and neutral wire( White) coming from the receiver and house 32. Lift the canopy into place so that the screw holes are aligned 33. Wrap keyhole slots around the screws and twist clockwise 34.
06 Install the lampshade 31. Lift the canopy cover to the canopy 32.
06 07 ① ⑤ ② ⑥ ① Fan ON/ OFF ② Fan Speed + ③ Fan Speed - ④ Foward/ Reverse ③ ⑦ ⑤ Light ON/ OFF ④ 8 ⑥ Warm light ⑦ Neutral light 8 White light After the reversible button is pressed, the fan slowly slows down to a stop. And then it started to reverse.
08 2. The Learn Key must be pressed within 5 seconds, after turning on the main switch. Keep pressing the button LEARN key in excess of 3 seconds it becomes a LEARN status. 3s 3. The indicator light of the remote flashes two times and the code is successful.
09 17
10 11 11 Website: www.sofucorfan.
19
20
21
22
