Safety Information 02 07 Warranty 03 08 04 09 05 10 06 11 5. Do not place objects in the path of the blades. 9. All set screws must be checked and re-tightened where neccessary before installation.
1.Place the gasket on the screw 3.Place the reinforcement gasket on the blade 5.Place the other blades one by one and tighten the screws 2.Place one blade on the motor and align the screw holes 4.Tighten the blade screws 6.
.Put on the lamp panel and feed the wire plugs through the center hole 8.Tighten the 3 silver lamp panel screws 9.Loosen and remove the 3 brass light kit screws pre-locked on the lamp panel(They will be needed later) 10.Connect the light source with the wires from the motor 11.Align the screw holes and tighten the 3 brass light kit screws 12.Turn the fan over 13.Loosen the 2 brass screws pre-locked on the top of the motor 14.
15.Remove the lock pin and the bolt of the base of the downrod 16.Select one downrod and pass all motor wires/light cables through it 3 holes 2 holes 17.Insert the bolt 18.Fix the bolt with the lock pin 19.Tighten the 2 screws to prevent fan shaking during operation 20.Put the decorative cover through the downrod 21.Put the canopy cover through the downrod 22.
23.Put the hanger ball through the downrod 24.Insert the bolt 25.Fix the green ground wire with screw. Align the screw hole and tighten the screw 26.Insert another screw and tighten the screw 27.Connect the wire from the ceiling fan to the receiver(Red,White and Black wires) 28.Connect the wire from the ceiling fan to the receiver(Red,White and Yellow wires) 29.Install the ceiling bracket with four self tapping screws 30.Place the downrod ball into the slot in the ceiling bracket.
31.Use wire connecting nuts to connect the two ground wires(Green)coming from the downrod and hanging bracket 32.Put the receiver into the mounting bracket WARNING: Turn off the electric power during installation and making wire connection 33.Lift the cannopy into place so that the screw holes are aligned 34.Wrap keyhole slots around the screws, twist clockwise and tighten 2 screws 35.Lift the canopy cover to the canopy 36.
① ④ ② ③ ⑤ ⑥ ⑦ ①ALL OFF: Turn off the lights and fans at the same time ②Light ON/OFF: Turn on/off the light only Light color temperature switch: Press twice continuously to switch another color temperature after turing on the light ③6 Speed Settings ④FAN ON/OFF: Turn on/off the fan only ⑤Timer: It will turn off the light and the fan when the time is over ⑥F/R: Changing fan runs direction ⑦Natural Wind
8 1 2 5 3 4
09
