KBS-52K037-BK-DC-WD-YH KBS-52K037-BK-DC-WD-SMW KBS-52K037-WH-DC-WD-YB KBS-52K037-BK-DC-WD-QMW-60 Email:sofucor_service@163.com Email:sofucorceilingfan@163.com www.sofucorfan.
01 Safety precaution Warranty Pre-Installation Ceiling installation Accessory drawing Install the blade Installing of downrod Hanging the Fan Remote control manual Match code Fans Balance Care and cleaning Trouble shooting 2 3 3 4 5 6 7 9 11 12 13 14 14 02 1. To reduce the risk of electric shock, ensure the electricity has been turned off at the circuit breaker or fuse box before you begin. 2.
03 The supplier warrants the fan motor to be free from defects in workmanship and material present at time of shipment from the factory for a lifetime after the date of purchase by the original purchaser. The supplier also warrants that all other fan parts, excluding any glass or acrylic blades, to be free from defects in workmanship and material at the time. of shipment from the factory for a period of two years after the date of purchase by the original purchaser.
04 Two ceiling installation methods 10 7 10 10 7 10 10 7 10 4
05 Accessory drawing 5
Installation Guide 06 Install the blades 01 02 03 04 05 06 6
Installation Guide 07 Installing of downrod 07 08 09 10 11 12 7
Installation Guide 07 Installing of downrod 13 14 15 8
17 16 9 Installation Guide 08 Assembly-hanging the Fan ( continued )
18 19 20 21 22 24 10 Installation Guide 08 Assembly-hanging the Fan ( continued )
Installation Guide 09 ① Fan Control Keys ① ② ② ALL OFF : Turn off the lights and ③ fans at the same time ③ F / R : Changing fan run direction ( 15 sec ) ④ Timer : It will turn off the light and the fan when the time is over ④ After the reversible button is pressed, the fan slowly slows down to a stop. And then it started to reverse.
10 Match code if it does not work 1.Turn on the main switch. 1 2.When turning on the main switch, press and hold the OFF key for three seconds. 2 3.
11 Adjusting and balancing your ceiling fan blades Slide the balancing clip on the trailing edge of any blade, halfway between the holder and tip. Run the fan to check the wobble. If the wobble persists, repeat with each blade, noting which one most reduced the wobble. Slide the clip in small increments away from the center of that blade. Move the clip, operate the fan, then move it again until you eliminate as much wobble as possible.
12 □ Because of the fan’s natural movement, some connections may become loose. Check the support connections, brackets, and blade attachments twice a year. Make sure they are secure. It is not necessary to remove the fan from the ceiling. □ Clean your fan periodically to help maintain its new appearance over the years. Do not use water when cleaning, as this could damage the motor, or the wood, or possibly cause an electrical shock. Use only a soft brush or lint-free cloth to avoid scratching the finish.
