Manual

16 | GETTING STARTED
Phase Invert Inverts the phase (polarity) of
the selected channel.
Preset/Save preset Calls up the Presets menu.
Press this while holding Shift
to save the current settings as
a preset.
Input Section
Input Gain Adjusts the gain of the incom-
ing signal of the selected track.
Input Gain meter Displays the signal level after
the Input Gain.
High Cut Sets the cuto frequency of
the High Cut lter. Turn fully
clockwise to bypass entirely
(leave the signal intact). When
Filters to Compressor is
activated, the lter is applied
to the compressor’s sidechain
signal.
Low Cut Sets the cuto frequency of
the Low Cut lter. Turn fully
counterclockwise to bypass en-
tirely (leave the signal intact).
When Filters to Compressor
is activated, the lter is applied
to the compressor’s sidechain
signal.
Fine Adjust/Shift Hold while you adjust a knob
to make the parameter change
in smaller increments, or to ac-
cess the extra functions labeled
in orange.
Filters to Compressor Shifts the High and Low Cut
lters from their default state
(aecting the audio signal) to
aecting the side-chain signal
of the compressor.
Input Gain Meter