User manual

Ping Test

• Connect the NetXpert 1400 to an active Ethernet port or cable.

• Touch Ping

from the Network test screen.

• Touch Add

. The saved target list will be displayed.

• Touch Add

or Edit to enter a new IP address or URL.

• Use the keypad to enter an IP or URL

• To edit or remove an address, touch an address under “IP/URL”

then touch Edit

or Delete .

• To add an IP address or URL to the target list, touch an address

under IP/URL then touch Add

• To ping the Targets, press the Test button

• To stop the ping test, press the Test button

Trace Route

Trace route is an ICMP ping test that shows much more detail than a

regular Ping Test. Choose a target and each device along the route

to the target will be displayed with a corresponding hop number.

The largest hop number will be the destination. If a device does not

respond to ICMP dashes will be shown next to the hop number. Three

pings will be sent to each hop and the response times will be shown.

• From the Network Test screen, touch Trace Route

• To Add/Edit trace route IP addresses, touch List

• To delete an address, touch Delete

• To add an IP address or URL, touch Add

• To edit an IP address or URL, touch Edit