User manual

Tone

The tone generator will transmit a frequency onto a cable to be

made audible using a tone probe. The tone generator will assist in

locating an inactive cable in a bundle, patch panel, or wall plate.

• From the Link Test screen

, touch Tone .

• Press the test button

to transmit the tone.

• Touch Previous

or Next to alternate which pin or pair to

transmit the tone.

• Touch Low/High to change the tone output level and cadence

(default is set to low).

• Use a tone probe to trace the tone alongside or at the end of the

cable.

Link Light

The Link light blinks the port LED on a switch or router to identify

which port the NetXpert 1400 is connected to.

• Connect the NetXpert 1400 to a cable that it plugged into an active

hub, switch or router.

• From the Link Test screen

, touch Link Light .

• Press the Test button

. The Link Light graphic will begin to

blink indicating that the test is running.

• The LED of the port you are connected to on a switch or router

will blink at a slow and consistent cadence for easy identiﬁcation.

• To select the Link speed, touch the Left

or Right arrows ..

The Link Light can be connected at 10Mbps half or full duplex,

100 Mbps half or full duplex, 1Gbps half or full duplex or auto.