User manual

25
Split:
The cable has been wired with correct continuity but not with
correct circuitry pairing. This most often happens when the cable is
terminated consistently at both ends but in the wrong order.
Skew:
The delay skew is higher than 35 nanoseconds. This may be caused by
velocity of propagation or length difference between the cable pairs.
SNR:
The Signal to Noise Ratio is lower than 22dB. This may be caused
by attenuation, excessive crosstalk, or noise that is imposed on
the cable from an external source such as electrical cabling,
uorescent lighting, or electrical equipment.
Saving Cable Tests as a PDF
In the Detailed Results screen there are two options; the NetXpert
1400 can save the last cable test results as PDF, or the entire test
list can be saved as a report.
• From the Detailed Result screen, touch More Options
.
• Touch PDF
.
• Enter the desired le name for your test and touch OK.
• NetXpert 1400 will save the PDF under your new le name to
external memory (SD Card).
Saving a PDF Report
• From the Detailed Results screen, touch More Options
.
• Touch the PDF Report
on the Cable Test screen.
• Enter the desired le name for your test report and touch OK.
• NetXpert 1400 will save the PDF under the new le name to
external memory (SD Card).
** DO NOT REMOVE SD CARD UNTIL DIALOG BOX DISAPPEARS**