User manual

23
• To delete highlighted entry, touch Delete .
• Touch OK to confirm action or cancel.
Select a Cable Type to Test
• Touch a cable type from the Cable Type list. Add the highlighted
cable type to the test list by touching Select
. The Cable Test
screen will appear with the added cable type displayed in the
lower left of the screen.
Cable Name
• From the Detailed Results screen, touch edit
.
• To enter a cable name prex touch Edit
. The prefix is the
first part of the cable name that does not increment when a
cable is added to the test list. Enter the desired prefix using the
touchscreen keypad and touch OK.
• Touch Cable Index
to edit the incrementing numerical portion
of the Cable ID. When the desired Index is entered, touch OK.
• To accept the changes, touch Save
. To exit without saving,
touch Cancel .
Ethernet Cable Test
• From the home screen, touch Cable Test
.
• Connect an Ethernet cable to the NetXpert 1400 then connect
the Active Remote to the opposite end of the cable. If an active
remote is not being used, connect a Network testing ID remote to
the opposite end of the cable.
* If testing an Ethernet cable that is terminated to a wall plate,
use the included RJ45 patch cables to connect to the wall plate or
modular RJ45 jack.
• Touch Cable Type
.
• Touch the desired cable type from the cable type list and then
touch Select Type
.
• Press the Test button
to perform a test. The NetXpert 1400
will add an incremented cable name to the Test List and perform
a test.